Key Features

• 24mm diameter
• Dual coil build deck (single coil possible)
• Adjustable honeycomb side airflow (16 holes per side)
• Deep juice well (~6mm)
• Top-mounted flathead post screws
• 810 wide bore resin drip tip
• Standard and BF squonk pin included
• Coil leg trimming tool included
• Designed by Mike Vapes & Hellvape

Compatibility

• Suitable for regulated & mechanical mods
• Best with dual 3mm ID coils
• Fits flush on most 24mm devices
• Compatible with high VG e-liquid
• Ideal for MTL-style dripping or squonking

Build Guide: Hellvape Rebirth RDA

What You’ll Need:
– 2x coils (3mm inner diameter recommended)
– Organic cotton
– Wire cutters / Coily tool
– Flathead screwdriver
– Ohm reader / regulated mod
– E-liquid

1. Trim Coil Legs to 6.5mm
   Use the included coil tool or Coily tool for perfect length and airflow alignment.
2. Install the Coils
   Insert coil legs vertically into the two-post deck. Secure with top screws.
3. Align the Coils
   Centre the coils slightly above the airflow holes to maximise flavour.
4. Dry Burn & Pulse
   Fire coils at low wattage and gently strum to remove hot spots.
5. Wick with Cotton
   Thread cotton through coils. Trim to just reach the bottom of the juice well.
6. Saturate & Reassemble
   Prime the cotton, replace the top cap, and adjust airflow to preference.
7. Drip or Squonk
   Use the standard pin for dripping, or switch to the BF pin for squonking mods.