Description

EARLY BIRD SPARROW REBUILDABLE ATOMISER

Introducing the Sparrow RTA by Early Bird, the brand’s debut rebuildable tank atomiser, designed by seasoned industry veterans. Although Early Bird is a new name, the designers behind it bring decades of experience, so you’re getting a refined device built with flavour and versatility in mind.

At 24 mm in diameter and 36 mm in height (without drip tip), it’s compact enough to sit flush on many mods without overhang yet doesn’t compromise on performance. 
The Sparrow features a top-to-bottom diffused airflow system where air enters at the top, travels down and then up through or around the coil, helping prevent leaks and delivering consistent, flavour-rich results.

You’ll find a single-coil deck (two-post design) that supports 2.5mm or 3mm pre-made coils — making builds straightforward for both beginners and experienced vapers. The wicking ports are generous, and the deck design intends to reduce the risk of dry hits or flooding.

For airflow control, the Sparrow gives you eight interchangeable airflow pins (1.0mm, 1.2mm, 1.5mm, 1.8mm, 2.2mm, 2.8mm, 3.4mm, 4.0mm) so you can tailor your draw from tight MTL through airy DTL.

An extension kit is included (barrel + chamber + extra glass) so you can increase tank capacity if required. 2ml with the standard and 3.7ml with the extension.

Key Features:

• Diameter: 24 mm – fits flush on most mods.
• Height: 36 mm (without drip tip)
• Top-to-bottom diffused airflow design (leak-resistant)
• Single-coil, two-post deck (supports up to 3mm inner diameter coils)
• 8 included airflow pins
  1mm, 1.2mm, 1.4mm, 1.8mm, 2.2mm, 2.8mm, 3.4mm, 4mm
• Large wicking ports for efficient cotton/juice flow
• Includes extension kit (barrel + chamber + glass) for increased capacity, 3.7ml
• Two 510 drip tips included (one for MTL/RDL, one for DTL)
• Suitable for MTL, RDL and DTL vaping styles
• Three finish colours: Black, Silver, Gunmetal
• Made with SS316 stainless steel

Box Contents:

• 1 × Sparrow RTA (24 mm)
• 1 × Short (comfort) 510 drip tip
• 1 × Extension barrel
• 1 × Extension chamber
• 1 × Extension glass
• 8 × airflow pins (1.0, 1.2, 1.5, 1.8, 2.2, 2.8, 3.4, 4.0 mm)
• 2nd 510 drip tip (wide for DTL)
• Spare parts pack (O-rings, screws, etc)
• User Manual

Suggested Usage & Build Tips:

• For tight MTL: use the 1.0 or 1.2 mm airflow pin, set top airflow nearly closed, install a 2.5mm coil with ~0.6–1.0Ω resistance, wick carefully.
• For RDL: use 1.8–2.2 mm pin, open top airflow more, install 3mm coil at ~0.4–0.6Ω.
• For DTL: use 2.8–4.0 mm pin, wide drip tip included, open top airflow fully.
• Ensure cotton tails are tucked into the wicking ports but not overly packed, the large ports allow good flow.
• When using extension kit, make sure o-rings are seated properly to avoid misfit/leak issues.